The passing coil should be aligned with the winding wheel holder

The passing coil should be aligned with the winding wheel holder. The closer the angle is to 90°, the more sensitive the response. (8) After the bait enters the water, there is no response after 20-30 minutes, then the rod should be raised and the bait changed again. After the sea pole is supported, a small bell is placed on the tip of the pole. Because the bait will disperse soon after entering the water, after half an hour, the bait will be eaten by the small fish, and the time will be wasted if the bait is not changed. (5) After the aconite falls into the water, immediately tu back the outlet ring and shake the reel handle to take up the line.

Generally, the fishing line is pulled by hand, as long as the line can be pulled. When you see the rod tip swinging sharply or ringing loudly, you can tu the loss by holding the rod back and raising the rod vigorously, then quickly take up the line, and after a few meters of the line, you have to raise the rod again, repeat this several times to make the hook fastened Fish lips. For more information, please visit China:. Hold the rod on the reel with your right hand, clamp the middle finger and ring finger on the reel to connect the back, hook the first joint of your index finger to the fishing line, flip out the loop, and cast the bait hook to the fishing spot according to your familiar throwing method. Therefore, this angle is the core of response sensitivity.

The method of using the sea rod is relatively complicated, but if it is applied properly, it is also handy to use, which can make our fishing more efficient. (4) Rotate the reel to make the bait group 30-40 cm away from the tip of the rod. As one of the most common types of fishing gear, how is it used? What are the steps to use the sea pole? (1) Pull the sea pole section by section so that the loops are aligned and in a straight line. (2) Install the reel, install the reel on the holder, fix it with a nut, tu the reel backstop switch to the reverse position, pull the thread head, the fishing line can be pulled out, and then one by one Pass through the coil until it passes through the pole tip. Then hang the aconite and bomb bait with the connecting ring to prepare for throwing.

When the line is retracted and the fishing line is still in a relaxed state, put the sea rod on the support, the elevation angle of the sea wholesale fishing tackle Manufacture rod (rod The height between the body and the ground should be larger, that is, steeper, and the elevation angle is directly related to the sensitivity of the rod tip.When we are preparing for fishing work, we will prepare all kinds of fishing gear. The joints of the sections should be tightened slightly. Generally speaking, the greater the elevation angle, the higher the sensitivity; on the contrary, the slower. Another criterion for judging whether the elevation angle is appropriate is the angle between the fishing rod and the fishing line. (6) In case of windy weather, a large elevation angle will make the fishing rod susceptible to the wind and swing. Each fishing gear has a different method of use. If it is too tight, the line resistance is too large, and the line will be easily broken when encountering a big fish; if it is too loose, the line resistance is too small, and the line will be too fast when encountering a big fish.

In order to increase the wind resistance of the sea pole, the elevation angle can be reduced, but not too small, which will reduce the sensitivity of the pole tip; in addition, the sea pole can also be retracted a few sections to reduce the pole height and also reduce the impact of wind; Or lay the sea rod on the shore, but pay attention to make the angle between the fishing rod and the fishing line close to 90° (7) After the sea rod is supported, you can react quietly, or listen to the bell, or watch the rod tip. (3) It is very important to tu the backstop switch back to the forward position and adjust the drag device